Anker NEBULA Cosmos Laser 4K Projector

Astronomical Content Options

Just a tap of a finger gives you access to 400,000+ movies and episodes on 7,000+ apps on Android TV 10.0, including the most popular streaming platforms.

Never Worry About Burnouts

With 25,000 hours of lamp life, you can comfortably binge-watch for years on the same bulb.

Connect Any Device

Use your phone, tablet, or USB drive to link with the Cosmos Laser series, so you can stream the content you want without hassle.

FAQ

1.How Do I Install the 4K Dongle?

1. Open the back cover of the projector by pushing and sliding it up.
2. Connect to the micro-USB connector and micro-HDMI connector.
3. Close the back cover.

2.How Do I Pair the Remote with Cosmos Laser 4K?

Use these two methods to pair the remote with Cosmos Laser 4K:
– During the setup process, hold the remote near the projector. On the remote, press the “Home” and “Back” buttons simultaneously for about 10 seconds per the on-screen instructions.
– During the pairing process, point the remote at the infrared receiver. Go to Settings > Remotes & Accessories > Add Accessory to search and pair.
Note:
The distance between the remote control and the projector should not exceed 10 m / 33ft.

3.How Do I Upgrade 4K Streaming Dongle’s Firmware?

Go to Settings> Device Preferences > About > System Update

4.How Do I Update the Firmware for Cosmos Laser 4K?

Go to Settings> Device Preferences > About > Projector Firmware Update

5.How Do I Find the MAC Address of Cosmos Laser 4K?

Go to Settings > Device Preferences > About > Status > MAC address.

6.How Do I Reset Cosmos Laser 4K?

To reset via the 4K dongle, go to Settings > Device Preferences > Reboot.
To reset via the projector, tap the Projector Settings on the top panel of your projector or press the Source button on the remote, then go to Advanced Settings > Back to default

7.How Do I Set Up the Cosmos Laser 4K Remote Buttons?

1. Go to Settings > Set up remote buttons > Add device > TV or Press the Settings button on the remote.
2. Select Nebula as the brand of TV.
3. Complete the setup by following the on-screen instructions.

8.How Should I Position Cosmos Laser 4K?

Position your projector with one of the following methods:
– Front: The projector is placed on a table in front of the screen. This is the most common way to position the projector for quick setup and portability.
– Rear: The projector is placed on a table behind the screen. A special rear projector screen is required.
– Front Ceiling: The projector is suspended upside-down in front of the screen. A ceiling/wall mount kit is required.
– Rear Ceiling: The projector is suspended upside-down from behind the screen. A special rear projector screen and ceiling/wall mount kit are required.

Notes:
– After turning on the projector, press the Projector Settings button on top of the projector, then go to Advanced Settings > Projector Mode to select a setting.
– It is unnecessary to tilt the projector toward the projection surface. Your projector has autofocus and auto keystone correction to create a well-sized and clear image.
– For more control over projector height, you can place it on a tripod (sold separately).
– The distance between the projector lens and the screen determines the projector screen size.

SPECS